You can change the order of the columns in decode view, and Summary and Sequence pane of stream view. You can also revert the order of the columns in Summary pane to default.

Changing the Order of Columns

Procedure 1

1. Drag a column header of the Summary or Sequence pane to right or left.
2. Drop it where you want to place it.

Procedure 2

1. Right-click on a column header of the Summary pane.
2. Choose [Columns...].
3. Click an item in the list.
4. Change its position in the list, clicking [Up] or [Down] button.

Note

• When you drag a column header, a border between two column headers will change into blue. When you drop the column header, it will be inserted at the position of the blue border.
• Drag the center of a column header by the mouse cursor. If you place the mouse cursor at the end of a column, it will change to the cursor for changing the column width.

Restore to the Initial Order

Procedure

1. Right-click on a column of the Summary pane.
2. Choose [Columns...].
3. Click [Default] button.
   This operation also restores the column width and the state of the columns, shown and hidden, to the initial status.

Note

• When the column width is 0 pixel, or greater than the width of a decode view or stream view, it is difficult to place a mouse cursor at an end of the column. In such cases, you can change the column width using [Width] of the [Configure Columns] dialog box.

References

• Toggling the Column of Summary Pane between Shown and Hidden
• Toggling the Toolbar of Decode or Summary View between Shown and Hidden
• Changing Fonts